Aquabot AB Classic In-ground Robotic Pool Cleaner

In stock
90% of 100
  • #1 Best Seller
  • Climbs and cleans walls
  • Built-in filter system
In stock
Ground Delivery Ground
This item ships via UPS Ground and usually arrives in 2 to 3 business days.

The pool cleaner of the future can be yours today with this computer-controlled, preprogrammed robotic cleaner! Has a built-in filter system so there are no hoses to drag out and no skimmer connections to make. Only 17 lbs., it vacuums debris from any size, shape, or type of pool, and scrubs pool surfaces of algae, bacteria and waterline build-up at 3,500 sq. ft. per hour and filters 4,000 gallons of water per hour. Includes reusable filter bag and 51 ft. floating cord. One year warranty.

ELECTRIC CLEANERS safely run off of a 24 volt transformer just like your home vacuum cleaner except that they move themselves automatically. Simply lower into your pool, plug in and turn on. Cleaners are programmed to randomly cover and vacuum the entire pool floor & walls. Debris on pool floor is vacuumed up and trapped in on-board filters. (Color may vary based on inventory).

For Technical support on this item please contact Aqua Products at 1-800-221-1750

  • Electrical Requirements:120VAC/60Hz
  • Power Consumption:230W
  • Dimensions:17" X 14 1/2" X 11 1/8"
  • Weight:19 lbs
  • Cable Length:50'
  • For In-Ground Pools
  • Shape:Rectangle, Lap, Kidney, L-Shape, Round, Oval
  • Surfaces:Vinyl, Gunite/Concrete, Fiberglass
  • Pool to Wall Transition:90 Degree Angle
  • 1 year warranty
Helpful Tips & Useful Information:

  • IMPORTANT: Alternate the diagonal locked position of the Floating Handle with each use of your cleaner! This will help reduce possible twisting of your Floating Cable and enable cleaning of any areas missed during the prior cleaning cycle!

  • Cleaner Start Position: Holding the Floating Handle, submerge your cleaner upside down, and gently rock it back and forth under the water to allow any trapped air to escape, which is critical for proper balancing or it may not clean and cover your pool as designed.

    While submerged turn upright, then let go allowing your cleaner to settle to a level area on the pool floor near the shallow end. Starting it on an inkling (like a deep end hopper) may cause the cleaner, program and sensors to mistakenly consider the incline as the floor, and conversely on the floor as the wall. This would offset its cleaning program and coverage, resulting in missed areas. Be sure to start the cleaner on a level surface every time.

    Turn ON Power Supply to begin cleaning.

  • Scrubbing Brushes Care and Replacement: Your cleaners Scrubbing Brushes provide traction and give it the ability to loosen debris. It is important that you not let the Brushes get worn down otherwise your cleaner may lose the ability to scrub, climb, turn and move to clean and cover all areas of the pool. Eventually you will need to change the Brushes on your cleaner. When they need replacement will depend upon how often you use your cleaner and upon the conditions of your pool. High chemical concentrations and rough surfaces will cause faster Brush wear. We recommend that you inspect Brushes frequently to check for excessive wear.

    The Molded Rubber Brushes that come standard on most cleaner models will function well on most any surface (including concrete, plaster, gunite, vinyl and pebble). The Super Brushes will work on virtually all surfaces other than highly polished tile. Foam Brushes are recommended for fiberglass and vinyl surfaces only. PVA Brushes are recommended for fiberglass, vinyl and highly polished tile.

  • Write Your Own Review